Legal Axle Weights in Utah

Legal Axle Weights in Utah

Aggregates: Vehicles engaged exclusively in the transportation of gravel, earth and rock filling, earth, sand, coal, phosphate sludge, asphalt or concrete may have a tolerance of 10% of the axle load regulations, except on interstate highways (Ky. Rev. Stat. § 189.222[10]). Pits: Trucks transporting sludge are limited to the following weights: one axle: 21,500; two axles: 37,000 lbs., three axles: 4,000 lbs above the corresponding limit in the state deck table; four axles: 6,000 lbs above the equivalent limit of the state deck table; Five or more axles: 7,000 lbs above the equivalent limit of the state deck table. The total weight allowed is limited to 80,000 lbs. This does not apply to Interstate Highways, with the exception of the following highways (on their federal designation I 39): Garbage / Garbage / Recycling: A vehicle operated by an authorized waste, garbage or recycling carrier is entitled to 22,000 pounds on a single axle and 40,000 lbs on a tandem axle on a nonstate highway (Nev. Rev. Stat. §484D.640). Livestock: Trucks transporting livestock may exceed applicable axle or group of axle limits by 15%. This increase does not apply to interstate highways, with the exception of the following highways (on their federal designation I 39): Lumberjack/logging equipment: If a vehicle is used to transport two, but not more than two, logging or logging equipment from one construction project to another, the Secretary may issue an annual special obesity permit to the person operating the vehicle. The permit authorizes the use of the truck, trailer and load on it at maximum axle weights intended for overload approval loads, with a gross vehicle weight not exceeding 105,000 lbs on non-interstate highways (La.

Rev. Stat. Ann. §32:387.10). Agricultural products: A farm vehicle that transports agricultural products on non-interstate highways within 100 miles of the harvested field to the point of first discharge can exceed state weight limits by up to 20% on each axle and have a tire load of up to 670 lbs. per inch of width (Mt. Code Ann. § 61-10-144). 68 The 100,000 lb limit Total weight applies to six-axle station wagons (three-axle tractor with three-axle semi-trailer).

[ Return to footnote 68 referrer. Special Harvest Season Permits: Upon request, the Secretary may issue special harvest season permits for vehicles or combinations of vehicles transporting natural agricultural and forestry products, seed modules, cotton seeds from gin to milling, raw sugar from milling to refinery, or grain of beer. Under these permits, the total gross weight limit is 86,600 lbs on non-interstate highways and 83,400 lbs on highways; The single axle limit is 22,000 lbs on non-interstate highways and 20,000 lbs on highways; and the tandem axle limit is 37,000 lbs, plus relevant axle weight tolerances, on non-interstate highways and 35,200 lbs on highways (La. Rev. Stat. Ann. §32:387[C][3]). The following vehicles have a margin of error of 10% relative to the actual gross weight or axle: Particleboard or fibreboard for the manufacture of ready-to-assemble furniture: An annual authorization may be issued authorizing the movement of particleboard or fibreboard intended for the manufacture of ready-to-assemble home or office furniture on certain roads that meets the permissible conditions set out in the Subchapter C (maximum vehicle weight).

exceed the total permissible weight of the vehicle. Permits issued under this Division shall not exceed a distance of 70 miles. The weight of a vehicle registered under this section shall not exceed 107,000 lbs. The following gross gross weight and maximum axle load limits apply to all non-steered axles: Drilling of pumps/concrete wells: A special permit may be issued for the operation of concrete pumps or well drilling rigs. Such permission may be granted for single or annual use (Mo. Ann. Stat. §304.180[7]).

In addition, state regulations allow for the issuance of a general permit for well drilling platforms, allowing up to £40,000 on a tandem axle and £60,000 on a tride axis group (Mo. Admin. Code. 7, §10-25.020[6][D][2]). Grains/seasonal crop products: Seasonal grains or crops can be transported from field to storage, market or storage in the field or from stock to market or factory, up to 70 miles with a load that exceeds the state weight limits of 15% tandem axle, axle group and GVW. Vehicles with only one rear axle may move equally on each individual axle and gross weight with an excess of 15 %. This exception applies only to non-interstate highways (including Rev. Stat. §60-6,301[5]). Exception: Passenger buses can carry 24,000 lbs on each axle, as long as they do not exceed the load capacity of the manufacturer`s tires.

This section frees them from the 34,000 lbs. Tandem and bridge restrictions. However, vehicles with five or more axles shall not have a tandem axle weight exceeding 44,000 lbs, and a six-axle combination of a three-axle truck and a three-axle semi-trailer shall not exceed a gross laden weight of 100,000 lbs. The tolerance for special goods does not apply to journeys under the intergovernmental system (Me. Rev. Stat. Ann. tit. 29-A, § 2357). 152 Articulated buses are defined as having three or more axles consisting of two sections connected by an articulated joint, the trailer being equipped with a power-steered rear axle and having a total weight not exceeding 60,000 lbs. [ Return to footnote 152 referrer.

] The formula limits the weight of axle groups to reduce the risk of damage to highway bridges. The permissible weight depends on the number of axles in a vehicle and the distance between those axles. However, the weight limits for single or tandem axles replace the limits of the bridge formula for all axles up to 96 inches apart.

Share this post